Others
Daihatsu CB80 ECU connectors word document  [26/12/2010]

CB80 ECU Connectors and colour codes & ECU pin out wiring diagram (by Rospen)


CB80 ECU Connector and colour code.

CB80 ECU Connector (looking at the ECU)

CODES

W – white

L – blue

G – green

Y – yellow

R – red

Br – brown

B – black

LB – light brown

  • when 2 colours the first is most dominant and the second is a stripe.
  1. W-L battery +, supplied from main relay
  2. W-G 12V +, supplied from EFI Fuse No.1,also to injector relay
  3. -
  4. W fuel pump relay coil
  5. NOT SURE CB80 – A/F adjuster
  6. Y water temp sensor
  7. Y-R pressure sensor - boost (MAP Sensor signal)
  8. Y-W air temp sensor
  9. Br-W test terminal
  10. W-R ignitor (RPM)
  11. R distributor
  12. B distributor
  13. Oxygen sensor signal (violet)
  14. L-Y TVSV – boost control solenoid
  15. B DSW – defogger and light switch
  16. B-W ST - starter
  17. B-R injectors
  18. Br earth (anti static shield)
  19. W-L + B2. 12V battery
  20. G-Y check engine lamp
  21. B-W A/C amplifier /clutch
  22. Y-R speed sensor
  23. W-B TPS and sensor ground
  24. Y-B TPS (Throttle position)
  25. Y-L TPS and pressure sensor
  26. Y-G TPS
  27. LB distributor
  28. W-B TPS and sensor ground
  29. G check terminal
  30. R-B VSV idle up
  31. Br Earth – anti static shield and test terminal
  32. R Ignitor +

Disclaimer:

This information is not factory endorsed. It has been interpreted from factory manuals by Rospen Motor Sport. Although we have taken care to ensure accuracy we bear no responsibility for any damage that may arise from the use of this information. Use at your own risk.

Rate: Daihatsu CB80 ECU connectors word document
Assessment



1472 Rating: 0.0/5 (0 votes cast)

Focus
ADS



Trang nhất |  News |  Auto Repair |  Software |  Repair Manual  |  Ebook |  Training |