Most read
Bài đọc nhiều
How to
Checking the thermostat [28/06/2011]
Step 1. Remove the thermostat . Hold the flange with pliers and submerge it in a pan of boiling water. The valve should open within approxi- mately 30 seconds. When fully open the thermostat valve will be about~in from its seating.
Step 1. Remove the thermostat . Hold the flange with pliers and submerge it in a pan of boiling water. The valve should open within approxi- mately 30 seconds. When fully open the thermostat valve will be about~in from its seating.
2. To refit, scrape clean the seating on the cylinder head. Some thermostats are marked with the word radiator’ or rad’ on the flange. This marking goes nearest to the radiator.
3. Fit a new gasket after the thermostat, smear with high- melting-point grease, replace the cover and tighten the fixings evenly.
Assessment
- How to Change Your Own Oil (01/03/2012)
- Door Will Not Latch Close (06/10/2011)
- How Air Bag Suspension Works (07/09/2011)
- From the outside (30/06/2011)
- How the oil circulates (29/06/2011)
- Changing the engine oil and filter (29/06/2011)
- Cleaning a centrifugal filter (28/06/2011)
- Cleaning a bowl-type filter (28/06/2011)
- Changing a cartridge filter (28/06/2011)
- Changing an exhaust manifold gasket (28/06/2011)
- Fitting new steady-bar rubber bushes (28/06/2011)
- Renewing engine mountings (28/06/2011)
- Checking externally-adjusted OHC clearances (28/06/2011)
- Overhead camshaft and fingers (28/06/2011)
- Pushrod and rocker (28/06/2011)
| More | ------------- |
Feedback | Hotline: (+84) 73.020.020 - (+84) 979.551.551 | Contact Advertising | Sitemap
Copyright © 2011 Automotive news
Automobiles Repair Manuals, Workshop Manuals, Special Tools
